Technical data

Chapter 2 Basic Configuration
Voice Interface Configuration with the Intial Configuration Dialog
2-10
Software Configuration Guide for the Cisco VG200
78-10322-02
Voice Interface Configuration with the Intial
Configuration Dialog
From this point on in the initial configuration dialog, the prompts you see vary
depending on the network modules in your gateway. The following sections
describe the steps for the optional interface modules that require additional
configuration using the intitial configuration dialog.
• ISDN BRI Interface Configuration, page 2-10
• E1/T1 ISDN PRI Configuration, page 2-15
ISDN BRI Interface Configuration
Use the initial configuration dialog to configure an ISDN BRI interface. This
configuration requires you to enter the ISDN switch type. These switch types are
shown in Table 2-1.
Table 2-1 ISDN Switch Types
Country ISDN Switch Type DescrIption
Australia basic-ts013 Australian TS013 switches
Europe basic-1tr6 German 1TR6 ISDN switches
basic-nwnet3 Norwegian NET3 ISDN switches
(phase 1)
basic-net3 NET3 ISDN switches (UK and
others)
basic-net5 NET5 switches (UK and others)
vn2 French VN2 ISDN switches
vn3 French VN3 ISDN switches
Japan ntt Japanese NTT ISDN switches
New Zealand basic-nznet3 New Zealand NET3 switches