Specifications

Send document comments to [e-mail].
2-11
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, Release 5.0(3)U2(2)
OL-25782-02
Chapter 2 Configuring IPv4
Configuring IPv4
SUMMARY STEPS
1. configure terminal
2. interface ethernet number
3. no switchport
4. ip proxy-arp
5. (Optional) copy running-config startup-config
DETAILED STEPS
This example shows how to configure Proxy ARP:
switch# configure terminal
switch(config)# interface ethernet 2/3
switch(config-if)# no switchport
switch(config-if)# ip proxy-arp
switch(config-if)# copy running-config startup-config
Configuring Local Proxy ARP
You can configure Local Proxy ARP on the switch.
SUMMARY STEPS
1. configure terminal
2. interface ethernet number
Command Purpose
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Enters configuration mode.
Step 2
interface ethernet number
Example:
switch(config)# interface ethernet 2/3
switch(config-if)#
Enters interface configuration mode.
Step 3
no switchport
Example:
switch(config-if)# no switchport
Configures the interface as a Layer 3 routed interface.
Step 4
ip proxy-arp
Example:
switch(config-if)# ip proxy-arp
Enables Proxy ARP on the interface.
Step 5
copy running-config startup-config
Example:
switch(config-if)# copy running-config
startup-config
(Optional) Saves this configuration change.