Specifications

Send document comments to [e-mail].
9-5
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, Release 5.0(3)U2(2)
OL-25782-02
Chapter 9 Configuring RIP
Configuring RIP
Configuring RIP
This section includes the following topics:
• Enabling the RIP Feature, page 9-5
• Creating a RIP Instance, page 9-6
• Configuring RIP on an Interface, page 9-8
• Configuring a Passive Interface, page 9-11
• Configuring Route Summarization, page 9-11
• Configuring Route Summarization, page 9-11
• Configuring Route Redistribution, page 9-12
• Configuring Virtualization, page 9-13
• Tuning RIP, page 9-16
Note If you are familiar with the Cisco IOS CLI, be aware that the Cisco NX-OS commands for this feature
might differ from the Cisco IOS commands that you would use.
Enabling the RIP Feature
You must enable the RIP feature before you can configure RIP.
SUMMARY STEPS
1. configure terminal
2. feature rip
3. (Optional) show feature
4. (Optional) copy running-config startup-config
Table 9-1 Default RIP Parameters
Parameters Default
Maximum paths for load balancing 16
RIP feature Disabled
Split horizon Enabled