Specifications

Send document comments to [e-mail].
xxii
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, Release 5.0(3)U2(2)
OL-25782-02
Preface
Organization
This document is organized into the following chapters:
Table 1 Supported Cisco Nexus 3000 Platform Switches
Switch Description
Cisco Nexus 3064PQ Switch The Cisco Nexus 3064UP switch is a high-performance,
high-density, ultra-low-latency Ethernet switch that is part of the
new Cisco Nexus 3000 Series Switches. This compact one-rack-unit
(1RU) form factor 1 and 10 Gigabit Ethernet switch provides
line-rate Layer 2 and 3 switching. The switch runs the
industry-leading Cisco NX-OS Software operating system,
providing customers with robust features and functionality that are
widely deployed globally. The Cisco Nexus 3064UP is well suited
for financial co-location deployments that require support for robust
unicast and multicast routing protocol features at ultra-low
latencies.
Title Description
Chapter 1, “Overview” Presents an overview of unicast routing and brief
descriptions of each feature.
Chapter 2, “Configuring IPv4” Describes how to configure and manage IPv4, including
ARP and ICMP.
Chapter 3, “Configuring OSPFv2” Describes how to configure the OSPFv2 routing protocol
for IPv4 networks.
Chapter 4, “Configuring EIGRP” Describes how to configure the Cisco EIGRP routing
protocol for IPv4 networks.
Chapter 5, “Configuring Basic BGP” Describes how to configure basic features for the BGP
routing protocol for IPv4 networks.
Chapter 6, “Configuring Advanced BGP” Describes how to configure advanced features for the
BGP routing protocol for IPv4 networks, including route
redistribution and route aggregation.
Chapter 7, “Configuring Bidirectional
Forwarding Detection for BGP”
Describes how to configure Bidirectional Forwarding
Detection (BFD) for BGP.
Chapter 8, “Configuring ECMP for Host
Routes”
Describes how to configure the equal-cost multipathing
(ECMP) protocol for host routes
Chapter 9, “Configuring RIP” Describes how to configure the RIP routing protocols for
IPv4 networks.
Chapter 10, “Configuring Static Routing” Describes how to configure static routing for IPv4
networks.
Chapter 11, “Configuring Layer 3
Virtualization”
Describes how to configure Layer 3 virtualization.
Chapter 12, “Managing the Unicast RIB
and FIB”
Describes how to view and modify the unicast RIB and
FIB.