Specifications

Send document comments to [e-mail].
6-33
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, Release 5.0(3)U2(2)
OL-25782-02
Chapter 6 Configuring Advanced BGP
Configuring Advanced BGP
This example shows how to redistribute EIGRP into BGP:
switch# configure terminal
switch(config)# router bgp 65536
switch(config-router)# address-family ipv4 unicast
switch(config-router-af)# redistribute eigrp 201 route-map Eigrpmap
switch(config-router-af)# copy running-config startup-config
Configuring Multiprotocol BGP
You can configure MP-BGP to support multiple address families, including IPv4 unicast and multicast
routes.
BEFORE YOU BEGIN
Ensure that you have enabled the BGP feature (see the “Enabling the BGP Feature” section on
page 5-11).
SUMMARY STEPS
1. configure terminal
2. router bgp as-number
3. neighbor ip-address remote-as as-number
4. address-family ipv4 {unicast | multicast}
5. (Optional) copy running-config startup-config
DETAILED STEPS
Command Purpose
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Enters configuration mode.
Step 2
router bgp as-number
Example:
switch(config)# router bgp 65536
switch(config-router)#
Enters BGP mode and assigns the autonomous system
number to the local BGP speaker.
Step 3
neighbor ip-address remote-as as-number
Example:
switch(config-router)# neighbor
192.168.1.2 remote-as 65537
switch(config-router-neighbor)#
Places the router in neighbor configuration mode for
BGP routing and configures the neighbor IP address.