Specifications

Send document comments to [e-mail].
4-9
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, Release 5.0(3)U2(2)
OL-25782-02
Chapter 4 Configuring EIGRP
Configuring Basic EIGRP
Configuring Basic EIGRP
This section includes the following topics:
• Enabling the EIGRP Feature, page 4-9
• Creating an EIGRP Instance, page 4-10
• Restarting an EIGRP Instance, page 4-12
• Shutting Down an EIGRP Instance, page 4-13
• Shutting Down EIGRP on an Interface, page 4-13
Enabling the EIGRP Feature
You must enable the EIGRP feature before you can configure EIGRP.
SUMMARY STEPS
1. configure terminal
2. feature eigrp
3. (Optional) show feature
4. (Optional) copy running-config startup-config
DETAILED STEPS
NSF convergence time 120
NSF route-hold time 240
NSF signal time 20
Redistribution Disabled
Split horizon Enabled
Table 4-1 Default EIGRP Parameters (continued)
Parameters Default
Command Purpose
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Enters configuration mode.
Step 2
feature eigrp
Example:
switch(config)# feature eigrp
Enables the EIGRP feature.