User guide

HP Virtual Connect for Cisco Network Administrators (version 4.x)

Document Number: C01386629 Date: January 2014

page 34

Create zoneset:

 zoneset name zoneset1 vsan 200

 member fcoe-zone

Activate zoneset:

 zoneset activate name zoneset1 vsan 200

Nexus switch-B configuration

Upgrade the second Nexus switch with minimum System version 5.2(1)N1(3) (enter: show version)

Enable FCoE on the switch (disabled by default):

 configure terminal

 feature fcoe

 feature lacp

Note: The Nexus will require a reload.

Associate a VLAN with a VSAN for FCoE traffic:

 vlan 201

 fcoe vsan 201

Create a port channel with eth1/5 and eth1/6 with the same LACP Timer as defined by default in the Virtual

Connect Domain, eth1/5 and eth1/6 can be used because both are mapped to the same UPC (i.e. UPC#1) on

Nexus:

 interface Ethernet1/5

 channel-group 200 mode active

 lacp rate fast

 interface Ethernet1/6

 channel-group 200 mode active

 lacp rate fast

Create the VLANs for the IP traffic:

 vlan 1,10,20

Create a trunk on the port channel interface to pass the FCoE (VLAN 200) and Ethernet traffic (VLAN 1,10,20):

 interface port-channel 200

 switchport mode trunk

 switchport trunk allowed vlan 1,10,20,201

 spanning-tree port type edge trunk