Installation guide

5-6
Cisco Network Convergence System 6000 Series Routers Hardware Installation Guide
Chapter 5 Installing Route Processor Cards, Line Cards, and Fabric Cards
Installing and Removing an Impedance Carrier
Figure 5-2 LC Slot Impedance Carrier
Step 1 Use both hands while inserting an impedance carrier. Use one hand on the faceplate and the other hand
along the base of the impedance carrier to guide it into the slot.
Step 2 Slide the impedance carrier into the chassis until the captive screw plates are flush with the chassis.
Step 3 Partially tighten the two captive screws on the front panel of the impedance carrier (either by hand or
with the number-2 Phillips screwdriver or number-2 common (flat-head) screwdriver) to make sure that
they are both engaged.
Step 4 Use the number-2 Phillips screwdriver or number-2 common (flat-head) screwdriver to fully tighten the
captive screws to seat the impedance carrier firmly in the slot.
122147