Installation guide

5-5

Cisco Network Convergence System 6000 Series Routers Hardware Installation Guide

Chapter 5 Installing Route Processor Cards, Line Cards, and Fabric Cards

Installing and Removing an Impedance Carrier

The chassis ships with impedance carriers installed in the LC slots.

• Installing an Impedance Carrier, page 5-5

• Removing an Impedance Carrier, page 5-7

Installing an Impedance Carrier

This section describes how to install an impedance carrier in the Cisco NCS 6008 LCC.

Prerequisites

Before performing this task, open the cosmetic doors, if installed, and ensure that the slot in which you

are about to install the impedance carrier is empty.

Required Tools and Equipment

• Number-2 Phillips screwdriver or number-2 common (flat-head) screwdriver

• LC impedance carrier (Cisco PID NC6-LC-BLANK)

Steps

To install an impedance carrier (Figure 5-2), perform the following steps: