Installation guide

5-29
Cisco Network Convergence System 6000 Series Routers Hardware Installation Guide
Chapter 5 Installing Route Processor Cards, Line Cards, and Fabric Cards
About Line Cards
Table 5-5 describes the LEDs for the 60-port 10Gbps SFP+ LC.
1. The Attention LED can only be lit by using the hw-module attention-led location CLI command which is useful for identifying
and verifying which card needs attention.
Physical Characteristics
• Height—22.5 in. (57.2 cm)
• Depth—15.75 in.(40 cm)
• Width—2.1 in. (5.3 cm)
• Weight—26 lb (11.8 kg)
Table 5-5 60-Port 10Gbps SFP+ LC LED Descriptions
LED State Description
Status Green The LC is properly seated and operating correctly.
Yellow The LC has one or more errors detected.
Off No power is applied to the LC.
Attention
1
Blue The card needs attention.
Off The card does not need attention.
Port Green The link is up (including internal loopback).
Yellow The link is down or a hardware failure has occurred.
Off The slice is unprovisioned by software, the optics
module is missing, or the slice has been powered
down.