Installation guide

5-22
Cisco Network Convergence System 6000 Series Routers Hardware Installation Guide
Chapter 5 Installing Route Processor Cards, Line Cards, and Fabric Cards
About Line Cards
S13 MC Fabric Card LEDs
Table 2 describes the LED indicators for the S13 MC FC.
• The Status LED and Attention LED indicate the status of the S13 MC fabric card. Each is a bi-color
green and yellow LED.
• The16 CXP LEDs indicate the status of the CXP links. Each is a bi-color red and green LED.
About Line Cards
The line cards for the Cisco NCS 6008 chassis are monolithic assemblies with optical interfaces, packet
processing, and CPU control plane fully integrated onto one board.
• 10-Port 100Gbps Line Card with CPAK Optics Module, page 5-22
• 10-Port 100Gbps Line Card with CXP Optics Module, page 5-24
• 60-Port 10Gbps Line Card with SFP+ Optics Module, page 5-27
10-Port 100Gbps Line Card with CPAK Optics Module
The 10-port 100Gbps CPAK LC (Lean Core [NC6-10X100G-L-K] and Multi-Service Core
[NC6-10X100G-M-K]) has:
• 10 ports that each accept a CPAK optics module
• Attention LED
• Status LED
• Port LEDs, one on each port
Figure 5-9 shows the front panel of the 10-port 100Gbps CPAK LC.
Table 2 S13 MC Fabric Card LED Indicators
LED LED Color Description
STATUS Green The card is properly installed and no faults are detected
Yellow The software initialization is in progress during bootup or a fault exists on the
board.
Flashing yellow (slow) The card is not fully seated or the slot has detected a parity error.
Off No power is applied to the card.
ATTN Blue On: The card needs attention. Off: The card does not require attention.
CXP (0 to 15) Green The port is correctly connected to the S2 FC card on the FCC.
Red One or more links are down. For troubleshooting information, see the System
Administration Command Reference for the Cisco NCS 6000 Series Routers.
Off The CXP module is not present or is not fully inserted in the S13 MC FC.