Installation guide

5-21
Cisco Network Convergence System 6000 Series Routers Hardware Installation Guide
Chapter 5 Installing Route Processor Cards, Line Cards, and Fabric Cards
Installing Fabric Cards
Verifying the Installation of an S13 MC Fabric Card
This section describes how to verify that an S13 MC FC card is properly installed and is working
correctly in the Cisco NCS 6000 LCC. Use the Status LED, located on the faceplate of the card to verify
the correct installation of the card. Figure 5-8 shows the front panel of the card. Table 2 describes the
LED indicators and their meanings.
Figure 5-8 S13 MC Front Panel
1 Status LED 3 16 CXP port LEDs (0 through 15, one per port)
2 Attention LED 4 16 CXP ports