Installation guide

5-19
Cisco Network Convergence System 6000 Series Routers Hardware Installation Guide
Chapter 5 Installing Route Processor Cards, Line Cards, and Fabric Cards
Installing Fabric Cards
Figure 5-7 Installing an S13 MC FC in a Cisco NCS 6008 LCC
Step 5
Place one hand under the card to support and position the card for insertion into the card cage slot. Avoid
touching the card circuitry or any connectors.
Note Alignment grooves exist on each slot in the card cage. When you install a card in the card cage,
make sure that you align both edges of the card carrier in the slot grooves.
1 Ejector lever 3 Captive screw
2 OIR buttons (top and bottom of faceplate)