Installation guide

5-13
Cisco Network Convergence System 6000 Series Routers Hardware Installation Guide
Chapter 5 Installing Route Processor Cards, Line Cards, and Fabric Cards
Installing Fabric Cards
Installing Fabric Cards
• Installing a NC6-FC Fabric Card, page 5-13
• Verifying the Installation of a NC6-FC Fabric Card, page 5-16
• About Line Cards, page 5-22
Installing a NC6-FC Fabric Card
Prerequisites
Before performing this task, open the cosmetic doors, if installed.
Required Tools and Equipment
• ESD-preventive wrist strap
• Number-2 Phillips screwdriver or number-2 common (flat-head) screwdriver
• Fabric Card (Cisco PID NC6-FC)
Steps
To install an FC (Figure 5-5), perform the following steps: