Installation guide

5-11
Cisco Network Convergence System 6000 Series Routers Hardware Installation Guide
Chapter 5 Installing Route Processor Cards, Line Cards, and Fabric Cards
Installing a Route Processor Card
Figure 5-4 RP Card Front Panel
1 Status LED—Card status indicator 8 IEEE 1588 Ethernet port
2 Attention LED 9 SYNC0 (BITS/J.211) port
3 Expansion Ethernet ports 10 SYNC1 (BITS/J.211) port
4 Interface Shelf Ethernet ports 11 Time/Frequency Expansion port
5 Three console ports 12
GPS ToD interface
(with 1-PPS and 10-MHz coax connectors)
6 External USB port 13 Alarm port
7 Two management LAN Ethernet ports
304080
1
2
3
6
8
9
10
11
13
4
5
12
7