Specifications

© 2006 Cisco Systems, Inc.
All rights reserved.
Product Features 2-46
NAM / Traffic Analyzer v3.5 Tutorial
© 2006 Cisco Systems, Inc. All rights reserved.
Product Features 2-46
NAM / Traffic Analyzer v3.5 Tutorial
Getting Started
Host Device Parameters - SNMP
Getting Started
Host Device Parameters - SNMP
Setup > Switch Parameters > Switch Information
Information about
the host switch and
available data
sources (VLAN,
NetFlow, NBAR)
Information about
the host switch and
available data
sources (VLAN,
NetFlow, NBAR)
Setup > Router Parameters > Router Information
NAM-1 and NAM-2
NAM-1 and NAM-2
NM-NAM
NM-NAM
Enter the same IP address and
read-write community string as was
configured on the router. Otherwise
the NAM cannot communicate via
SNMP with the router
Enter the same IP address and
read-write community string as was
configured on the router. Otherwise
the NAM cannot communicate via
SNMP with the router
Host Parameters - SNMP
During installation of the NAM-1/2, the NAM is made aware of the SNMP community strings set of the host
switch allowing for the retrieval of mini-RMON information. However, in the case of the NM-NAM, you must
configure the NM-NAM with the community strings configured on the host access router to allow the NM-NAM
to retrieve the MIB-II interface, router health, and NBAR-PD statistics from the router’s SNMP agent. To do
so, enter the Cisco access router’s read-write community strings in the Setup > Router Parameters > Router
Information submenu.