Specifications

© 2006 Cisco Systems, Inc.
All rights reserved.
Product Features 2-37
NAM / Traffic Analyzer v3.5 Tutorial
© 2006 Cisco Systems, Inc. All rights reserved.
Product Features 2-37
NAM / Traffic Analyzer v3.5 Tutorial
Getting Started
NAM Hardware Installation Overview
Getting Started
NAM Hardware Installation Overview
Cisco
Catalyst
6500 Series
or Cisco
7600 Series
NAM with Integrated
Traffic Analyzer
Software
NAM-1, NAM-2
Cisco ISR 2600XM, 2800,
3660, 3700, 3800, 2691
Series Routers
NM-NAM
NAM Hardware Installation Overview
NAM-1 and NAM-2
The NAM-1/2 installs into a single slot on the Cisco Catalyst
®
6500 series and Cisco 7600 series chassis. The
host switch must meet the required operating system (OS) versions. A complete listing of supported OS and
supervisor hardware can be found in Chapter 4. The NAM can be installed in any slot on the host Cisco
Catalyst® Switch, except for the slot(s) that are reserved for the Supervisor module(s). After the NAM is
installed, check that the NAM status is OK by using the show mod command via either CatOS or IOS.
NM-NAM
The NM-NAM installs into a single slot on the Cisco 2600XM, 2800, 3660, 3700, and 3800 Series access routers.
The host router must meet the required operating system versions. A complete listing of supported OS and
hardware can be found in Chapter 4. After you have installed the NAM into the chassis, check that the status of
the enable (EN) LED. This LED indicates that the module has passed its self-tests and is available to the router.
Note(s):
• Refer to Chapter 4 in this tutorial for more detailed guidelines on installing and troubleshooting the NAM
and the appropriate NAM Installation Guide for more detailed instructions on configuring these parameters.