Specifications

© 2006 Cisco Systems, Inc.
All rights reserved.
System Admin 4-30
NAM / Traffic Analyzer v3.5 Tutorial
© 2006 Cisco Systems, Inc. All rights reserved.
Sys tem Admin 4-30
NAM / Traffic Analyzer v3.5 Tutorial
NAM Maintenance
Shutdown
NAM Maintenance
Shutdown
Do not remove NAM until shutdown process is complete!
NAM-1, NAM-2: Status Light = Orange
NM-NAM: console message - %SERVICEMODULE-5-SHUTDOWN2:Service module NAM-Sensor1/0 shutdown complete
Do not remove NAM until shutdown process is complete!
NAM-1, NAM-2: Status Light = Orange
NM-NAM: console message - %SERVICEMODULE-5-SHUTDOWN2:Service module NAM-Sensor1/0 shutdown complete
Option 1 - Issue shutdown command from NAM CLI.
Option 2 - Issue module shutdown command from supervisor CLI.
Option 3 - If above two options fail, then press the shutdown button on NAM.
NAM-1/NAM-2
Status LED
NAM-1, NAM-2
NAM-1, NAM-2
NM-NAM
NM-NAM
Issue shutdown command from Router CLI:
Router# service-module analysis-module slot/0 shutdown
NAM-1, NAM-2 Shutdown
If it becomes necessary to remove the NAM from the host or to power off either the NAM or the host, the
NAM must first be properly shut down to avoid damaging the hard disk.
NAM-1, NAM-2
There are three methods to shutdown the NAM-1, NAM-2. The preferred method is to issue the shutdown
command from the root account of the NAM CLI. When the shutdown is complete, the status light on the
NAM will be orange, and the show module output will indicate that the status of the NAM as down. The NAM
also can be shutdown from the switch CLI. Note that the switch CLI can also be used to disable the NAM
module. The difference is that the NAM cannot be reset until the module is enabled first.
If either of these methods fails, the NAM can be shutdown by pressing the shutdown button on the front panel
of the NAM.
NM-NAM
The NM-NAM is shutdown from the router’s Exec-level CLI by issuing the command service-module
analysis-module slot/0 shutdown.
Note: The shutdown procedures can take several minutes.