Installation manual

-709
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR
xconnect logging redundancy
xconnect logging redundancy
To enable system message log (syslog) reporting of the status of the xconnect redundancy group, use the
xconnect logging redundancy command in global configuration mode. To disable syslog reporting of
the status of the xconnect redundancy group, use the no form of this command.
xconnect logging redundancy
no xconnect logging redundancy
Syntax Description This command has no arguments or keywords.
Defaults Syslog reporting of the status of the xconnect redundancy group is disabled.
Command Modes Global configuration
Command History
Usage Guidelines Use this command to enable syslog reporting of the status of the xconnect redundancy group.
Examples The following example enables syslog reporting of the status of the xconnect redundancy group and
shows the messages that are generated during switchover events:
Router# config t
Router(config)# xconnect logging redundancy
Router(config)# exit
Activating the Primary Member
00:01:07: %XCONNECT-5-REDUNDANCY: Activating primary member 10.55.55.2:1000
Activating the Backup Member:
00:01:05: %XCONNECT-5-REDUNDANCY: Activating secondary member 10.55.55.3:1001
Release Modification
12.0(31)S This command was introduced.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.4(11)T This command was integrated into Cisco IOS Release 12.4(11)T.
12.2(33)SRB This command was integrated into Cisco IOS Release 12.2(33)SRB.
12.2(33)SXI This command was integrated into Cisco IOS Release 12.2(33)SXI.
12.4(19)MR2 This command was integrated into Cisco IOS Release12.4(19)MR2.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.