Installation manual

-334
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR
pseudowire-class
pseudowire-class
To specify the name of a Layer 2 pseudowire-class and enter pseudowire-class configuration mode, use
the pseudowire-class command in global configuration mode. To remove a pseudowire class
configuration, use the no form of this command.
pseudowire-class pw-class-name
no pseudowire-class pw-class-name
Syntax Description
Defaults No pseudowire-class is defined.
Command Modes Global configuration
Command History
Usage Guidelines The pseudowire-class command configures a pseudowire-class template that consists of configuration
settings used by all attachment circuits bound to the class. A pseudowire-class includes the following
configuration settings:
• Data encapsulation type
• Control protocol
• IP address of the local Layer 2 interface
• Type of service (ToS) value in IP headers
The local interface name for each pseudowire class configured between a pair of PE routers can be the
same or different.
After entering the pseudowire-class command, the router switches to pseudowire-class configuration
mode where PW settings can be configured.
pw-class-name The name of a Layer 2 pseudowire-class.If you want to configure more than
one pseudowire class, define a class name using the pw-class-name
parameter.
Release Modification
12.0(23)S This command was introduced.
12.3(2)T This command was integrated into Cisco IOS Release 12.3(2)T.
12.2(25)S This command was integrated into Cisco IOS Release 12.2(25)S.
12.2(27)SBC Support for this command was integrated into Cisco IOS Release 12.2(27)SBC.
12.4(19)MR2 This command was integrated into Cisco IOS Release 12.4(19)MR2.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
15.0(1)MR This command was integrated into Cisco IOS Release 15.0(1)MR.