Installation manual

-284

Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Command Reference, Cisco IOS Release 15.1(3)MR

OL-26895-01

Chapter Cisco MWR 2941 Router Command Reference, Release 15.1(3)MR

network-clock wait-to-restore global

To configure the amount of time that the router waits before reverting to a restored clock source, use the

network-clock wait-to-restore command in global configuration mode. To remove a wait-to-restore

configuration, use the no form of this command.

network-clock wait-to-restore timer-value global

no network-clock wait-to-restore timer-value global

Syntax Description

Defaults 300 seconds or 5 minutes.

Command Modes Global configuration (config)

Command History

Usage Guidelines Using a low wait-to-restore value can cause timing flaps if the connection to a clock source is repeatedly

interrupted. We recommend a minimum value of 50 seconds to avoid timing flaps.

Examples This example shows how to configure a wait-to-restore timer:

Router(config)# network-clock wait-to-restore 200

Router(config)#

Related Commands

timer-value The length of the timer in seconds. The range is from 0 to 86400.

Release Modification

15.0(1)MR This command was introduced.

Command Description

network-clock

wait-to-restore

To configure the amount of time that an interface waits before reverting

to a restored clock source