Specifications

8-14
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 8 Configuring IEEE 802.1Q Tunneling and Layer 2 Protocol Tunneling
Configuring Layer 2 Protocol Tunneling
Layer 2 Protocol Tunneling Configuration Guidelines
These are some configuration guidelines and operating characteristics of Layer 2 protocol tunneling:
• The router supports tunneling of CDP, STP, including multiple STP (MSTP), and VTP. Protocol
tunneling is disabled by default but can be enabled for the individual protocols on 802.1Q tunnel
ports, access ports. or trunk ports.
• The edge switches on the outbound side of the service-provider network restore the proper Layer 2
protocol and MAC address information and forward the packets to all Layer 2 protocol-enabled
tunnel, access, and trunk ports in the same metro VLAN.
• For interoperability with third-party vendor switches, the switch supports a Layer 2 protocol-tunnel
bypass feature. Bypass mode transparently forwards control PDUs to vendor switches that have
different ways of controlling protocol tunneling.When Layer 2 protocol tunneling is enabled on
ingress ports on a switch, egress trunk ports forward the tunneled packets with a special
encapsulation. If you also enable Layer 2 protocol tunneling on the egress trunk port, this behavior
is bypassed, and the switch forwards control PDUs without any processing or modification.
• If an encapsulated PDU (with the proprietary destination MAC address) is received from a tunnel
port or access or trunk port with Layer 2 tunneling enabled, the tunnel port is shut down to prevent
loops. The port also shuts down when a configured shutdown threshold for the protocol is reached.
You can manually re-enable the port (by entering a shutdown and a no shutdown command
sequence). If errdisable recovery is enabled, the operation is retried after a specified time interval.
• Only decapsulated PDUs are forwarded to the customer network. The spanning-tree instance
running on the service-provider network does not forward BPDUs to tunnel ports. CDP packets are
not forwarded from tunnel ports.
• When protocol tunneling is enabled on an interface, you can set a per-protocol, per-port, shutdown
threshold for the PDUs generated by the customer network. If the limit is exceeded, the port shuts
down. You can also limit BPDU rate by using QoS ACLs and policy maps on a tunnel port.
• When protocol tunneling is enabled on an interface, you can set a per-protocol, per-port, drop
threshold for the PDUs generated by the customer network. If the limit is exceeded, the port drops
PDUs until the rate at which it receives them is below the drop threshold.
• Because tunneled PDUs (especially STP BPDUs) must be delivered to all remote sites so that the
customer virtual network operates properly, you can give PDUs higher priority within the
service-provider network than data packets received from the same tunnel port. By default, the
PDUs use the same CoS value as data packets.
Drop threshold None set.
CoS value If a CoS value is configured on the interface, that value is used to
set the BPDU CoS value for Layer 2 protocol tunneling. If no CoS
value is configured at the interface level, the default value for CoS
marking of L2 protocol tunneling BPDUs is 5. This does not apply
to data traffic.
Table 8-1 Default Layer 2 Ethernet Interface VLAN Configuration (continued)
Feature Default Setting