Specifications

7-11
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 7 Configuring VLANs
Displaying VLANs
Note You can use the show vtp status command to verify the VTP status of the router.
Displaying VLANs
Use the show vlan privileged EXEC command to display a list of all VLANs on the router, including
extended-range VLANs. The display includes VLAN status, ports, and configuration information.
Table 7-3 lists other privileged EXEC commands for monitoring VLANs.
For more details about the show command options and explanations of output fields, see the command
reference for this release.
Command Purpose
Step 1
enable Enter enable mode.
Step 2
configure terminal Enter configuration mode.
Step 3
vtp mode transparent Set the router in VTP transparent mode.
Step 4
exit Exit configuration mode.
Table 7-3 VLAN Monitoring Commands
Command Purpose
show interfaces [vlan vlan-id] Display characteristics for all interfaces or for the specified
VLAN configured on the router.
show vlan [id vlan-id] Display parameters for all VLANs or the specified VLAN on the
router.
show vlan [vlan-name]
uni-vlan type
Display UNI-ENI isolated or UNI-ENI community VLANs by
VLAN name.
show vlan uni-vlan Display UNI-ENI community VLANs and associated ports on the
router.
show vlan uni-vlan type Display UNI-ENI isolated and UNI-ENI community VLANs on
the router by VLAN ID.