Specifications

6-2
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 6 Configuring HWIC-D-9ESW Interfaces
When you have completed the configuration, connect a crossover Ethernet cable from FastEthernet port
8 of the HWIC-D-9ESW card to the GigabitEthernet port that you want to use as a stacking partner.
For more information about how to configure other features on the HWIC-D-9ESW card, see Chapter 5,
“Configuring Layer 2 Interfaces.”
Note Both stacking partner ports must have their speed and duplex parameters set to auto.
Caution If stacking is removed, stacked interfaces will go to shutdown state. Other nonstacked ports will be left
unchanged.
Note For more detailed instructions on how to connect cables, see the Cisco MWR 2941-DC Mobile Wireless
Edge Router Hardware Installation Guide.
Step 7
interface gigabitethernet
partner-interface-id
Example:
Router# interface gigabitethernet 0/3/1
Specifies the partner-interface, and enters interface configuration
mode.
• Enter the partner interface number.
Note When you configure the FastEthernet port as a stacking
partner, the corresponding GigabitEthernet interface is
automatically configured as a stacking partner.
Step 8
no shutdown
Example:
Router(config-if)# no shutdown
Activates the stacking partner interface.
Step 9
end
Example:
Router(config-if)# end
Exits configuration mode.
Command or Action Purpose