Specifications

5-3
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 5 Configuring Layer 2 Interfaces
Configuring Layer 2 Optional Interface Features
Caution Changing the interface speed and duplex mode configuration might shut down and re-enable the
interface during the reconfiguration.
Configuring the Interface Speed
Follow these steps to configure the speed of a layer 2 interface.
Configuring the Interface Duplex Mode
Follow these steps below to set the duplex mode of a layer 2 interface.
Command Purpose
Step 1
enable
Example:
Router> enable
Router#
Enter enable mode.
Step 2
configure terminal
Example:
Router# configure terminal
Router(config)#
Enter configuration mode.
Step 3
interface interface slot/port
Example:
Router(config)# interface
fastethernet 1/0
Enter configuration mode for the interface that you want to modify.
Step 4
speed [10 | 100 | auto ]
Example:
Router(config-if)# speed auto
Specify the interface speed. You can set an interface to 10 Mbps,
100 Mbps, or autonegotiate.
Command Purpose
Step 1
enable
Example:
Router> enable
Router#
Enter enable mode.
Step 2
configure terminal
Example:
Router# configure terminal
Router(config)#
Enter configuration mode.