Specifications

CHAPTER

5-1

Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR

OL-26895-01

Configuring Layer 2 Interfaces

The Cisco MWR 2941 has an onboard layer 2 Gigabit Ethernet switch and supports HWICs with layer

2 interfaces.To configure the layer 2 interfaces on the Cisco MWR 2941, complete the following tasks:

• Configuring a Range of Interfaces, page 5-1

• Defining a Range Macro, page 5-2

• Configuring Layer 2 Optional Interface Features, page 5-2

Configuring a Range of Interfaces

The interface range command allows you to configure multiple interfaces at once. Follow these steps

to configure an interface range.

Command Purpose

Step 1

enable

Example:

Router> enable

Router#

Enter enable mode.

Step 2

configure terminal

Example:

Router# configure terminal

Router(config)#

Enter configuration mode.

Step 3

interface range interface slot/port

- port

Example:

Router(config)# interface range

GigabitEthernet 0/1 - 3

Use the interface-range command to select a range of interfaces to

configure. You can specify a range that includes both VLANs and

physical interfaces.