Specifications

29-10
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 29 Monitoring and Managing the Cisco MWR 2941 Router
Configuring Network Management Features
show controllers t1 Information about cable length, framing,
firmware, and errors associated with the T1. With
the Cisco MWR 2941 router, this command also
shows the status of the relays on the VWIC.
show dsl interface atm Displays information specific to the asymmetric
digital subscriber line (ADSL) for a specified
ATM interface.
show gsm traffic Traffic rates in bits per second at 1 second,
5 seconds, 1 minute, 5 minutes, and 1 hour
intervals for GSM data transmitted and received
over the backhaul.
show gsm-abis efficiency [history] The history of the GSM efficiency averages for
compression/decompression at 1-second,
5-second, 1-minute, 5-minute, and 1-hour
intervals.
show gsm-abis errors Error statistics counters of the GSM for
compression/decompression.
show gsm-abis packets Packet statistics counters of the GSM for
compression/decompression.
show gsm-abis peering [details] Peering status, statistics, and history of the GSM
compression/decompression.
show interface type slot/port Configuration and status of the specified
interface.
show interface switchport backup Status information about the backup switchport.
show interface virtual-cem slot/port Status of the CEM interface.
show interface gigabitethernet slot/port Status of the FE interface.
show ip mroute Contents of the multicast routing (mroute) table.
Note Multicast routing applies only to PTP
redundancy.
show ip rtp header-compression RTP header compression statistics.
show ip tcp header-compression Transmission Control Protocol (TCP)/IP header
compression statistics
Note The Cisco MWR 2941 supports UDP
header-compression in IEFT format only.
show mpls l2transport vc Information about Any Transport over MPLS
(AToM) virtual circuits (VCs) that are enabled to
route Layer 2 packets on a router.
show network-clocks Network clocking configuration.
show platform hardware Status of hardware devices on the
Cisco MWR 2941 router.
show policy-map Configuration of all classes for a specified service
policy map or of all classes for all existing policy
maps.
Command Purpose