Specifications

29-9
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 29 Monitoring and Managing the Cisco MWR 2941 Router
Configuring Network Management Features
Show Commands for Monitoring the Cisco MWR 2941 Router
To monitor and maintain the Cisco MWR 2941 router, use the following commands:
Step 6
Router(config)# snmp-server host
hostname [traps | informs] [version
{1 | 2c | 3 [auth | noauth |
priv]}] community-string [udp-port
port] [notification-type]
Specifies the recipient of a Simple Network Management Protocol
(SNMP) notification operation.
The hostname is the name assigned to the Cisco Info Center workstation
with the ip host command in Step 3.
Step 7
Router(config)# snmp-server
community public RO
Router(config)# snmp-server
community private RW
Specifies the public and private SNMP community names.
Step 8
Router(config)# snmp-server enable
traps
Enables the transmission of SNMP traps.
Step 9
Router(config)# snmp-server
trap-source loopback number
Specifies the loopback interface from which SNMP traps should
originate, where number is the number of the loopback interface you
configured for the O&M in Step 4.
Step 10
exit
Example:
Router(config)# exit
Router#
Exits configuration mode.
Command Purpose
Command Purpose
show atm cell-packing Information about Layer 2 transport ATM
cell-packing.
show cem circuit Summary about the CEM circuit state, including
controller, interface, and AC.
Also displays specific CEM circuit state, circuit
parameters, and statistics/counters.
show cem platform CEM errors and information.
show connection Displays the status of interworking connections.
show controllers All network modules and their interfaces. Also
displays the status of the VWIC relays when a
VWIC is installed.
show controllers gigabitethernet slot/port Information about initialization block, transmit
ring, receive ring, and errors for the Fast Ethernet
controller chip.
show controllers e1 Information about controller status specific to the
controller hardware. Also displays statistics about
the E1 link. If you specify a slot and a port
number, statistics for each 15-minute period
appears.