Specifications

28-6
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 28 Configuring Traffic Storm Control
Monitoring and Maintaining Storm Control
Monitoring and Maintaining Storm Control
You can use the following privileged EXEC commands to monitor and maintain traffic storm control on
the Cisco MWR 2941:
Step 3
errdisable recovery interval seconds
Example:
Router(config-if)# errdisable recovery interval 30
Specifies the time, in seconds, to recover from a
specified error-disable cause. The range is from 30 to
86400. The default interval is 300.
Step 4
end
Example:
Router(config-if)# end
Exits interface configuration mode.
Command Purpose
Command Purpose
show errdisable recovery Displays the information about the error-disable recovery
timer.
show storm-control [GigabitEthernet number] [[broadcast |
multicast | unicast] [GigabitEthernet number]]
Displays the storm-control levels configured on the
interface.
show interfaces interface-id counters {broadcast | multicast
| unicast}
Example:
Router# show interfaces multilink1 counters broadcast
Displays a single counter for all suppressed traffic. These
commands all display the same discard count, which shows
the total number of packets discarded for all three traffic
storm control modes, on all interfaces or on the specified
interface.
Note The show interfaces [{interface_type slot/port} |
{port-channel number}] counters command does
not display the discard count. You must use one of
the traffic-type keywords: broadcast, multicast, or
unicast, which all display the same discard count.