Specifications

26-3
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 26 Configuring Link Noise Monitor
Usage Notes
• If the span command is issued without either the set or clear keywords specified, set is the default.
• The set and clear keywords can only be specified if the threshold and/or duration has been specified.
• If the PCV threshold is not configured (using the pcv keyword and value), the threshold is calculated
using Gaussian probability distribution that is representative of most noise environments.
• The following SYSLOG messages have been added for fault notification:
- %LNM-4- WARNEXCEED:Controller <Controller IF>, exceeded noise warning threshold
<int>, duration <int>
- %LNM-4- WARNIMPROVE:Controller <Controller IF>, noise improved below threshold
<int>, duration <int>
- %LNM-2-REMOVE:Interface <Serial IF> removed, noise exceeded threshold <int>,
duration <int>
- %LNM-2- RESTORE:Interface <Serial IF> restored, noise improved below threshold
<int>, duration <int>
- %LNM-2- REMEXCEED:Interface <Serial IF>, noise exceeded threshold <int>,
duration <int>
- %LNM-2- REMIMPROVE:Interface <Serial IF>, noise improved below threshold <int>,
duration <int>