Specifications

25-26
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 25 Configuring Quality of Service
Sample Quality of Service Configurations
For more information about configuring shaping, see the Quality of Service Solutions Configuration
Guide, Cisco IOS Release 15.0S.
Note The Cisco MWR 2941 does not support all of the commands described in the IOS Release 15.0S
documentation.
Configuring Ethernet Trusted Mode
The Cisco MWR 2941 supports trusted and non-trusted mode for switch ports. Switch ports are set in
non-trusted mode by default; if you want to set the Ethernet switch ports in trusted mode, use the global
command switch l2trust to set all Ethernet ports to trusted mode.
Router(config)# switch l2trust
For more information about the switch l2trust command, see the Cisco MWR 2941 Mobile Wireless
Edge Router IOS Command Reference, Release 15.0(1)MR.
Sample Quality of Service Configurations
The following sample configurations demonstrate how you can apply QoS configurations on the
Cisco MWR 2941.
Note This section provides partial configurations intended to demonstrate a specific feature.
The following sections provide sample configurations for QoS on the Cisco MWR 2941.
• Switchport Priority
• Classification and Marking
• Priority Queuing
For more information about configuring QoS, see “Configuring Quality of Service” section on
page 25-1.
Switchport Priority
The following sample configuration demonstrates how to mark P-bit values on incoming traffic on the
9ESW HWIC interface.
...............
interface GigabitEthernet0/2
no ip address
switchport stacking-partner interface FastEthernet1/8
...............
interface FastEthernet1/7
switchport mode trunk
switchport priority override 7 ! set all ingress traffic to priority 7