Specifications

25-21
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 25 Configuring Quality of Service
Configuring Quality of Service
interface Vlan999
description for XYZ
ip address 200.200.200.1 255.255.255.252
load-interval 30
service-policy output qos-marking
exit
interface GigabitEthernet0/0
description for XYZ
switchport trunk allowed vlan 999
switchport mode trunk
load-interval 30
end
Ingress Classification on DSCP with Multiple Values to Multiple COS Values with Table Map Configuration Mode
map Commands in a Single Table Map Statement
table-map stream
map from 46 to 5
map from 0 to 0
map from 34 36 38 to 4
map from 26 28 30 to 3
map from 18 20 22 to 2
map from 10 12 14 to 1
default copy
exit
policy-map qos-marking
class class-default
set qos-group dscp table stream
interface Vlan999
description for XYZ
ip address 200.200.200.1 255.255.255.252
load-interval 30
service-policy output qos-marking
exit
interface GigabitEthernet0/0
description for XYZ
switchport trunk allowed vlan 999
switchport mode trunk
load-interval 30
end
For information about the commands used in these configuration examples, see the Cisco IOS Software
Release 15.1M&T documentation:
http://www.cisco.com/en/US/partner/products/ps10592/tsd_products_support_series_home.html
Monitoring and Maintaining MLPPP Ingress DSCP Marking
You can use the following privileged EXEC commands to monitor and maintain traffic storm control on
the Cisco MWR 2941:
Command Purpose
show table-map table-map-name Displays the configuration of a specified table map.
show policy-map policy-map-name Displays the configuration of all classes for a specified
service policy map attached to the SVI interface.
show interfaces vlan vlan-num Displays the statistics of SVI interface