Specifications

23-34
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 23 Configuring Pseudowire
Configuration Examples for Pseudowire
protocol none
ip local interface Loopback 0
!
controller E1 0/13
clock source internal
cem-group 0 timeslots 1-31
!
interface cem 0/13
cem 0
xconnect 2.2.2.9 200 pw-class udpClass
udp port local 50000 remote 55000
Note You cannot use the vrf interface as a tunnel source to establish the PW. You must use only the interface
which is present in the global routing table.
ATM over MPLS Configuration
This example shows how to accomplish the following configurations (Figure 23-5):
Note Release 15.1(1)MR does not support N-to-1 VCC Cell Transport for mapping multiple PVCs, 1-to-1
VCC Cell Mode, or PVC mapping.
• AAL5 SDU mode PW on 0/1 PVC 0/100
• N:1 VCC cell mode PW on 0/1 PVC 0/101
• Multiple PVCs N:1 VCC cell mode PW on 0/1.1
• 1:1 VCC cell mode PW on 0/1 PVC 0/102
• Cell-packing for port mode PWs
• VCC cell-relay mode PWs
• PVC mapping for 0/1.1 N:1 VCC cell relay PWs
Figure 23-5 ATM over MPLS Configuration
MWR_A
!
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
!
hostname mwr_A
!
Node-B
MWR_A
ATM0/0
ATM0/1
2.2.2.2/24 2.2.2.3/24
ATM0/0
ATM0/1
MWR_B
88.88.88.88 99.99.99.99
RNC
253033
GigabitEthernet0/1
GigabitEthernet0/1