Specifications

23-11
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 23 Configuring Pseudowire
Configuring Pseudowire
Note For more information about configuring IMA groups, see the “Configuring ATM IMA” section on
page 18-6.
Configuring an IMA Interface
If you want to use ATM IMA backhaul, follow these steps to configure the IMA interface.
Step 6
Router(config-controller)#
ima-group 0 scrambling-payload
If you want to configure an ATM IMA backhaul, use the ima-group
command to assign the interface to an IMA group. For a T1 connection,
use the no-scrambling-payload to disable ATM-IMA cell payload
scrambling; for an E1 connection, use the scrambling-payload parameter
to enable ATM-IMA cell payload scrambling.
The example assigns the interface to IMA group 0 and enables payload
scrambling.
Step 7
exit
Example:
Router(config)# exit
Router#
Exits configuration mode.
Command Purpose
Command Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.