Specifications

23-10
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 23 Configuring Pseudowire
Configuring Pseudowire
Configuring Transportation of Service Using ATM over MPLS
ATM over MPLS pseudowires allow you to encapsulate and transport ATM traffic across an MPLS
network. This service allows you to deliver ATM services over an existing MPLS network.
The following sections describe how to configure transportation of service using ATM over MPLS:
• Configuring the Controller
• Configuring an IMA Interface
• Configuring the ATM over MPLS Pseudowire Interface
Note For sample configurations for ATM over MPLS, see Configuration Examples for Pseudowire.
Configuring the Controller
Follow these steps to configure the controller.
Step 15
Router(config-if-cem)# exit
Router(config)#
Exits the CEM interface.
Step 16
exit
Example:
Router(config)# exit
Router#
Exits configuration mode.
Command Purpose
Command Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
Router(config)# card type e1 0 0
Configures IMA on an E1 or T1 interface.
Step 4
Router(config)# controller E1 0/4
Router(config-controller)#
Specifies the controller interface on which you want to enable IMA.
Step 5
Router(config-controller)# clock
source internal
Sets the clock source to internal.