Specifications

CHAPTER

18-1

Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR

OL-26895-01

Configuring MLPPP Backhaul

To configure an MLPPP backhaul, complete the following tasks:

• Configuring the Card Type, page 18-1

• Configuring E1 Controllers, page 18-2

• Configuring T1 Controllers, page 18-4

• Configuring ATM IMA, page 18-6

• Configuring T1 and E1 Local Switching, page 18-7

• Configuring a Multilink Backhaul Interface, page 18-10

Configuring the Card Type

Perform a basic card type configuration by enabling the router, enabling an interface, and specifying the

card type as described below. You might also need to enter other configuration commands, depending

on the requirements for your system configuration and the protocols you plan to route on the interface.

Note In the following procedure, press the Return key after each step unless otherwise noted. At any time,

you can exit the privileged level and return to the user level by entering disable at the Router# prompt.

To select and configure a card type, follow these steps:

Command Purpose

Step 1

enable

Example:

Router> enable

Enables privileged EXEC mode.

• Enter your password if prompted.

Step 2

configure terminal

Example:

Router# configure terminal

Enters global configuration mode.