Specifications

16-27
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 16 Configuring Clocking and Timing
Clocking Sample Configurations
PTP Input Timing
The following sample configuration sets the router as a PTP master clock with input timing enabled
using the 10Mhz timing port.
Note This section only applies to the Cisco MWR 2941-DC-A router; the Cisco MWR-DC router does not
have the timing ports used in this example.
Note This section provides a partial configuration intended to demonstrate a specific feature.
ptp mode ordinary
ptp priority1 128
ptp priority2 128
ptp domain 0
ptp input 10M 1pps
ptp tod iso
ptp update-calendar
interface GigabitEthernet 0/0
switchport access vlan 1588
interface vlan 1588
ip address 192.168.15.89 255.255.255.0
ip igmp join-group 224.0.1.129
ptp sync interval -6
ptp delay-req interval -4
ptp master multicast
ptp enable
network-clock-select hold-timeout 3600
network-clock-select 1 10M
PTP Output Timing
The following sample configuration sets the router as a PTP slave clock with output timing enabled on
the 10M timing port.
Note This section only applies to the Cisco MWR 2941-DC-A router.; the Cisco MWR-DC router does not
have the timing ports used in this example.
Note This section provides a partial configuration intended to demonstrate a specific feature.
ptp mode ordinary
ptp priority1 128
ptp priority2 128
ptp domain 0
ptp output 10M 1pps
ptp tod ubx delay 1
ptp update-calendar