Specifications

16-26
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 16 Configuring Clocking and Timing
Clocking Sample Configurations
PTP Hybrid Mode
The following section shows a sample PTP configuration that uses hybrid mode. For more information
about how to configure PTP hybrid mode, see “Hybrid Clocking” section on page 16-3.
Note This section provides a partial configuration intended to demonstrate a specific feature.
ptp mode ordinary
ptp priority1 128
ptp priority2 128
ptp domain 1
interface Vlan1
ip address 192.168.1.2 255.255.255.0
ptp announce interval 3
ptp announce timeout 2
ptp sync interval -4
ptp delay-req interval -4
ptp slave multicast hybrid
ptp enable
network-clock-select 1 SYNCE 0/1
PTP Hot Standby Master Clock
The following section shows a sample PT P configuration that uses a hot standby master clock. For more
information about how to configure a PTP hot standby master clock, see “Configuring PTP Clocking”
section on page 16-4.
Note This section provides a partial configuration intended to demonstrate a specific feature.
ptp mode ordinary
ptp priority1 128
ptp priority2 128
ptp domain 1
ptp best-recovered-quality 2 30
interface Vlan1
ip address 192.168.1.2 255.255.255.0
ptp announce interval 3
ptp announce timeout 2
ptp sync interval -4
ptp delay-req interval -4
ptp slave unicast negotiation
ptp clock-source 10.0.1.2
ptp clock-source 10.0.1.3
ptp enable
network-clock-select 1 PACKET_TIMING