Specifications

15-53
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 15 Configuring Ethernet OAM, CFM, and E-LMI
Configuring Microwave 1+1 Hot Standby Protocol
ODU Configuration Values
HSBY protocol specifies that some values on the ODU are configurable while others utilize fixed values.
Table 15-6 summarizes the permitted values for an ODU using HSBY protocol.
IDU Configuration Values
HSBY protocol specifies that some values on the IDU are configurable while others utilize fixed values.
Table 15-7 summarizes the permitted values for an IDU using HSBY protocol.
Configuring HSBY
Follow these steps to configure HSBY protocol on the Cisco MWR 2941.
Table 15-6 HSBY ODU Configuration Parameters Summary
Parameter Default Value Permitted Values
Short MA Name Learned 0–65535
MPID 2 Fixed
MA VLAN-ID (E-CCM) None 16–50
Table 15-7 HSBY IDU Configuration Parameters Summary
Parameter Default Value Permitted Values
Domain Name Null Fixed
Domain Level 0 Fixed
Short MA Name None 0–65535
MPID 1 Fixed
MA VLAN-ID (E-CCM) None 1–15
CC Interval 100 ms 10 ms, 100 ms, and 1000 ms
Note Release 15.0(1)MR
does not support 10ms
CC intervals.
Suspend Interval 160 seconds 80 s, 160 s, 240 s, and 320 s
Command Purpose
Step 1
configure terminal Enters global configuration mode.
Step 2
interface gigabitethernet slot/port Enters configuration for the interface connected to ODU 1.
Note HSBY is permitted only on Gigabit Ethernet
interfaces 0/0–0/5.
Step 3
ethernet cfm mep domain domain-name mpid mpid
{port | vlan vlan-id}
Defines a CFM MEP domain for ODU 1.