Specifications

15-18
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 15 Configuring Ethernet OAM, CFM, and E-LMI
Configuring Ethernet CFM
Manually Configuring an IP SLAs CFM Probe or Jitter Operation
Beginning in privileged EXEC mode, follow these steps to manually configure an IP SLAs Ethernet echo
(ping) or jitter operation:
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
ip sla operation-number Create an IP SLAs operation, and enter IP SLAs
configuration mode.
Step 3
ethernet echo mpid identifier domain domain-name
vlan vlan-id
or
ethernet jitter mpid identifier domain domain-name
vlan vlan-id [interval interpacket-interval]
[num-frames number-of frames transmitted]
Configure the IP SLAs operation as an echo (ping) or jitter
operation, and enter IP SLAs Ethernet echo configuration
mode.
• Enter echo for a ping operation or jitter for a jitter
operation.
• For mpid identifier, enter a maintenance endpoint
identifier. The identifier must be unique for each
VLAN (service instance). The range is 1 to 8191.
• For domain domain-name, enter the CFM domain
name.
• For vlan vlan-id, the VLAN range is from 1 to 4095.
• (Optional—for jitter only) Enter the interval between
sending of jitter packets.
• (Optional—for jitter only) Enter the num-frames and
the number of frames to be sent.
Step 4
cos cos-value (Optional) Set a class of service value for the operation.
Step 5
frequency seconds (Optional) Set the rate at which the IP SLAs operation
repeats. The range is from 1 to 604800 seconds; the default
is 60 seconds.
Step 6
history history-parameter (Optional) Specify parameters for gathering statistical
history information for the IP SLAs operation.
Step 7
owner owner-id (Optional) Configure the SNMP owner of the IP SLAs
operation.
Step 8
request-data-size bytes (Optional) Specify the protocol data size for an IP SLAs
request packet. The range is from 0 to the maximum size
allowed by the protocol being used; the default is 66 bytes.
Step 9
tag text (Optional) Create a user-specified identifier for an IP SLAs
operation.
Step 10
threshold milliseconds (Optional) Specify the upper threshold value in
milliseconds (ms0 for calculating network monitoring
statistics. The range is 0 to 2147483647; the default is
5000.
Step 11
timeout milliseconds (Optional) Specify the amount of time in ms that the IP
SLAs operation waits for a response from its request
packet. The range is 0 to 604800000; the default value is
5000.