Specifications

15-10
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 15 Configuring Ethernet OAM, CFM, and E-LMI
Configuring Ethernet CFM
Step 14
mip auto-create [lower-mep-only | none] (Optional) Configure auto creation of MIPs for the service.
• lower-mep-only—Create a MIP only if there is a MEP
for the service in another domain at the next lower
active level.
• none —No MIP auto-create.
Step 15
exit Return to ethernet-cfm configuration mode.
Step 16
mip auto-create [lower-mep-only] (Optional) Configure auto creation of MIPs for the domain.
• lower-mep-only—Create a MIP only if there is a MEP
for the service in another domain at the next lower
active level.
Step 17
mep archive-hold-time minutes (Optional) Set the number of minutes that data from a
missing maintenance end point is kept before it is purged.
The range is 1 to 65535; the default is 100 minutes.
Step 18
exit Return to global configuration mode.
Step 19
interface interface-id Specify an interface to configure, and enter interface
configuration mode.
Step 20
switchport mode trunk (Optional) Configure the port as a trunk port.
Step 21
ethernet cfm mip level level-id (Optional) Configure a customer level or service-provider
level maintenance intermediate point (MIP) for the
interface. The MIP level range is 0 to 7.
Note This step is not required if you have entered the
ethernet cfm mip auto-create global
configuration command or the mip auto-create
ethernet-cfm or ethernet-cfm-srv configuration
mode.
Step 22
ethernet cfm mep domain domain-name mpid
identifier {vlan vlan-id | port}
Configure maintenance end points for the domain, and
enter Ethernet cfm mep mode.
• domain domain-name—Specify the name of the
created domain.
• mpid identifier—Enter a maintenance end point
identifier. The identifier must be unique for each
VLAN (service instance). The range is 1 to 8191.
• vlan vlan-id—Enter the service provider VLAN ID or
IDs as a VLAN-ID (1 to 4094), a range of VLAN-IDs
separated by a hyphen, or a series of VLAN IDs
separated by comma.
• port—Configure port MEP.
Step 23
cos value (Optional) Specify the class of service (CoS) value to be
sent with the messages. The range is 0 to 7.
Step 24
end Return to privileged EXEC mode.
Step 25
show ethernet cfm maintenance-points {local |
remote}
Verify the configuration.
Command Purpose