Specifications

14-18
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 14 Configuring Resilient Ethernet Protocol
Configuration Examples for REP
BPA (STCN, LSL) TLV rx: 0, tx: 0
BPA (STCN, HFL) TLV rx: 0, tx: 0
EPA-ELECTION TLV rx: 118, tx: 118
EPA-COMMAND TLV rx: 0, tx: 0
EPA-INFO TLV rx: 4214, tx: 4190
Sample MWR 2941 Topology: Example
The following configuration example shows two Cisco MWR 2941 routers and two Cisco 7600 series
routers using a REP ring.
Note This section provides partial configurations intended to demonstrate a specific feature.
2941_1
interface GigabitEthernet0/0
switchport trunk allowed vlan 1,2
switchport mode trunk
rep segment 1
!
interface GigabitEthernet0/1
switchport trunk allowed vlan 1,2
switchport mode trunk
rep segment 1
!
interface GigabitEthernet0/3
switchport access vlan 3
!
interface GigabitEthernet0/4
switchport access vlan 4
!
interface Vlan1
ip address 172.18.40.70 255.255.255.128
no ptp enable
!
interface Vlan2
ip address 1.1.1.1 255.255.255.0
no ptp enable
!
interface Vlan3
ip address 2.2.2.2 255.255.255.0
no ptp enable
!
interface Vlan3
ip address 4.4.4.2 255.255.255.0
no ptp enable
!
ip route 3.3.3.0 255.255.255.0 1.1.1.4
ip route 5.5.5.0 255.255.255.0 1.1.1.4
2941_2
interface GigabitEthernet0/0
switchport trunk allowed vlan 1,2
switchport mode trunk