Specifications

14-17
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 14 Configuring Resilient Ethernet Protocol
Configuration Examples for REP
Figure 5 Example of VLAN Blocking
Setting the Preemption for VLAN Load Balancing: Example
The following is an example of setting the preemption for VLAN load balancing on a REP segment.
Router> enable
Router# configure terminal
Router(config)# rep preempt segment 1
Router(config)# end
Configuring SNMP Traps for REP: Example
This example configures the router to send REP traps at a rate of 10 traps per second:
Router> enable
Router# configure terminal
Router(config)# snmp mib rep trap-rate 10
Router(config)# end
Monitoring the REP Configuration: Example
The following is sample output of the show interface rep detail command. Use the show interface rep
detail command on one of the REP interfaces to monitor and verify the REP configuration.
Router# show interface gigabitethernet0/1 rep detail
GigabitEthernet0/1 REP enabled
Segment-id: 2 (Edge)
PortID: 00010019E7144680
Preferred flag: No
Operational Link Status: TWO_WAY
Current Key: 0002001121A2D5800E4D
Port Role: Open
Blocked Vlan: <empty>
Admin-vlan: 100
Preempt Delay Timer: disabled
Load-balancing block port: none
Load-balancing block vlan: none
STCN Propagate to: none
LSL PDU rx: 3322, tx: 1722
HFL PDU rx: 32, tx: 5
BPA TLV rx: 16849, tx: 508
E2E1
4
201891
Alternate port (offset 4)
blocks VLANs 100-200
Primary edge port E1
blocks all VLANs except
VLANs 100-200