Specifications

14-14
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 14 Configuring Resilient Ethernet Protocol
Configuring Resilient Ethernet Protocol (REP)
Beginning in privileged EXEC mode, follow these steps on the switch that has the segment primary edge
port to manually trigger VLAN load balancing on a segment:
Configuring SNMP Traps for REP
You can configure the switch to send REP-specific traps to notify the SNMP server of link operational
status changes and port role changes. Beginning in privileged EXEC mode, follow these steps to
configure REP traps:
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
rep preempt segment segment-id
Example:
Router(config)# rep preempt segment 1
Manually triggers VLAN load balancing on the segment.
• Enter the segment ID.
Note You will be asked to confirm the action before the
command is executed.
Step 4
end
Example:
Router(config)# end
Returns to privileged EXEC mode.
Step 5
show rep topology
Example:
Router# show rep topology
Views the REP topology information.
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.