Specifications

13-8
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Chapter 13 Configuring Cisco Express Forwarding
Configuring Cisco Express Forwarding
Enabling or Disabling Cisco Express Forwarding Per-Destination Load
Balancing
Perform this task to enable or disable Cisco Express Forwarding per-destination load balancing.
Note The Cisco MWR 2941 router does not support per-packet load balancing.
Cisco Express Forwarding per-destination load balancing is enabled by default on the Cisco MWR 2941;
therefore no configuration is required to use this feature.
Note You cannot disable per-destination load balancing.
To display information about CEF sessions, use the show ip cef exact-route command.
Selecting a Cisco Express Forwarding Load-Balancing Algorithm
Perform one of the following tasks to elect a Cisco Express Forwarding load-balancing algorithm.
• Selecting a Tunnel Load-Balancing Algorithm for Cisco Express Forwarding Traffic, page 13-8
• Selecting an Include-Ports Layer 4 Load-Balancing Algorithm for Cisco Express Forwarding
Traffic, page 13-9
The router is set to perform universal load sharing by default.
Selecting a Tunnel Load-Balancing Algorithm for Cisco Express Forwarding Traffic
Perform the following task to select a tunnel load-balancing algorithm for Cisco Express Forwarding
traffic. Select the tunnel algorithm when your network environment contains only a few source and
destination pairs.
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.