Specifications

Contents
xiv
Cisco MWR 2941 Mobile Wireless Edge Router Release 3.5 Software Configuration Guide, Cisco IOS Release 15.1(3)MR
OL-26895-01
Configuring IPv6 BFD on an SVI Interface 22-5
Configuring IPv6 BGP on the Cisco MWR 2941 22-7
Configuring BFD for IS-IS 22-8
Configuring BFD for IS-IS on a Single Interface 22-9
Configuring BFD for IS-IS for All Interfaces 22-9
Configuring BFD for Static Routes 22-10
Configuration Examples for BFD 22-11
OSPF with BFD 22-11
BGP with BFD 22-14
IPv6 BFD with IPv6 BGP 22-17
IS-IS with BFD 22-17
CHAPTER 23 Configuring Pseudowire 23-1
Understanding Pseudowire 23-1
Structure-Agnostic TDM over Packet 23-2
Structure-Aware TDM Circuit Emulation Service over Packet-Switched Network 23-2
Transportation of Service Using ATM over MPLS 23-2
Transportation of Service Using Ethernet over MPLS 23-3
Limitations 23-3
Configuring Pseudowire 23-3
Using Pseudowire Classes 23-4
Using CEM Classes 23-5
Configuring a Backup Peer 23-6
Configuring Structure-Agnostic TDM over Packet (SAToP) 23-7
Configuring Circuit Emulation Service over Packet-Switched Network (CESoPSN) 23-7
Configuring a CESoPSN Pseudowire with UDP Encapsulation 23-9
Configuring Transportation of Service Using ATM over MPLS 23-10
Configuring the Controller 23-10
Configuring an IMA Interface 23-11
Configuring the ATM over MPLS Pseudowire Interface 23-12
Configuring Transportation of Service Using Ethernet over MPLS 23-17
Configuring VLAN Mode 23-17
Configuration Examples for Pseudowire 23-18
Asymmetric PWE3 Configuration 23-18
PWE3 Redundancy Configuration 23-26
TDM over MPLS Configuration 23-30
CESoPSN with UDP Configuration 23-33
ATM over MPLS Configuration 23-34
Ethernet over MPLS Configuration 23-39