Specifications

4-20
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Chapter 4 Configuring the Cisco MWR 2941 Router Using the CLI
Configuration Sequence
Router(config)# snmp mib rep trap-rate 10
Step 5 Exit configuration mode.
Router(config)# end
Router#
You can use the show running-config command to verify your configuration.
Monitoring REP
You can use the following commands to monitor REP.
• show interface [interface-id] rep [detail]—Displays REP configuration and status for a specified
interface or for all interfaces. The following example shows sample output for this command.
Router# show interface gigabitethernet0/0 rep
Interface Seg-id Type LinkOp Role
---------------------- ------ -------------- ----------- ----
GigabitEthernet0/0 2 TWO_WAY Open
sh int gig0/0 rep detail
GigabitEthernet0/0 REP enabled
Segment-id: 2 (Segment)
PortID: 0001002255000284
Preferred flag: No
Operational Link Status: TWO_WAY
Current Key: 05020014A91176C0B1C0
Port Role: Open
Blocked VLAN: <empty>
Admin-vlan: 1
Preempt Delay Timer: disabled
Configured Load-balancing Block Port: none Configured Load-balancing Block VLAN: none
STCN Propagate to: none LSL PDU rx: 239621, tx: 183515 HFL PDU rx: 9, tx: 1 BPA TLV
rx: 86252, tx: 11033 BPA (STCN, LSL) TLV rx: 0, tx: 0 BPA (STCN, HFL) TLV rx: 0, tx: 0
EPA-ELECTION TLV rx: 39, tx: 82 EPA-COMMAND TLV rx: 0, tx: 0 EPA-INFO TLV rx: 19037,
tx: 19075
• show rep topology [segment segment_id] [archive] [detail]—Displays REP topology information
for a segment or for all segments, including the primary and secondary edge ports in the segment.
The following example shows sample output for this command.
Router# show rep topology segment 2
REP Segment 2
BridgeName PortName Edge Role
---------------- ---------- ---- ----
switch1 Gi6/2 Pri Alt
switch3 Gi0/1 Open
switch3 Gi0/0 Open
switch2 Gi0/0 Open
switch2 Gi0/1 Open
switch4 Gi0/0 Open
switch4 Gi0/3 Open
switch5 Gi0/11 Sec Open