Specifications

B-568
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
xconnect
l2transport configuration (for ATM)
Connect configuration
Global configuration
Command History
Usage Guidelines The xconnect command allows provisioning an AToM static pseudowire. Use the manual keyword in
the xconnect command to place the router in xconnect configuration mode. MPLS pseudowire labels are
configured using the mpls label and (optionally) mpls control-word commands in xconnect
configuration mode.
The combination of the peer-ip-address and vcid arguments must be unique on the router. Each xconnect
configuration must have a unique combination of peer-ip-address and vcid configuration.
The same vcid value that identifies the attachment circuit must be configured using the xconnect
command on the local and remote PE routers. The vcid argument creates the binding between a PW and
an attachment circuit.
The use of the xconnect command and the interface configuration mode bridge-group commands is not
supported on the same physical interface.
Note If the remote router is a Cisco 12000 series Internet router, the peer-ip-address argument must specify
a loopback address on that router.
The pw-class keyword with the pw-class-name value binds the xconnect configuration of an attachment
circuit to a specific pseudowire class. In this way, the pseudowire class configuration serves as a
template that contains settings used by all attachment circuits bound to it with the xconnect command.
Note If you specify the encapsulation keywords, you must specify the pw-class keyword.
ignore-vpi-vci Keyword
Using the xconnect command with the ignore-vpi-vci keyword provides benefits over using the pw-pvc
command for PVC mapping.
Release Modification
12.0(23)S This command was introduced.
12.0(28)S Support was added for Multilink Frame Relay connections.
12.3(2)T This command was integrated into Cisco IOS Release 12.3(2)T.
12.2(25)S This command was integrated into Cisco IOS Release 12.2(25)S.
12.2(27)SBC This command was integrated into Cisco IOS Release 12.2(27)SBC.
12.4(11)T This command was integrated into Cisco IOS Release 12.4(11)T.
12.2(33)SRB This command was updated to add support for AToM static pseudowires, and
so that the remote router ID need not be the Label Distribution Protocol (LDP)
router ID of the peer.
12.4(19)MR2 This command was integrated into Cisco IOS Release 12.4(19)MR2.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
12.2(33)MRB The manual keyword was added.