Specifications

B-547
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
signaling
signaling
Specifies the signaling type used on a CEM interface. To disable a signaling configuration, use the no
form of this command.
signaling [inband-cas]
no signaling [inband-cas]
Syntax Description
Command Default This command is disabled by default.
Command Modes CEM interface configuration
Command History
Examples The following example shows how the signaling command is used in an E1 controller configuration.
Router(config-if)# controller e1 0/0
Router(config-controller)# mode cas
Router(config-controller)# cem-group 0 timeslots 1-31
Router(config-controller)# interface CEM 0/0
Router(config-if)# cem 0
Router(config-if-cem)# signaling inband-cas
Router(config-if-cem)# xconnect 30.30.30.2 305 encapsulation mpls
Related Commands
inband-cas Specifies inband channel-associated signaling (CAS) on the CEM interface.
Release Modification
12.4(20)MR This command was introduced.
12.2(33)MRA This command was integrated into Cisco IOS Release 12.2(33)MRA.
Command Description
cem-group Creates a circuit emulation (CEM) channel from one or more time
slots of a T1 or E1 line.
controller Configures a T1, E1, or BITS controller and enters controller
configuration mode.
mode cas Allows you to specify the controller mode for ATM, T1, or E1
controllers and enters controller configuration mode.