Specifications

B-528
Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB
OL-21227-02
Appendix B Cisco MWR 2941 Router Command Reference
show policy-map interface
offered rate Rate, in kbps, of packets coming in to the class.
Note If the packets are compressed over an outgoing interface, the
improved packet rate achieved by packet compression is not
reflected in the offered rate. Also, if the packets are classified
before they enter a combination of tunnels (for example, a generic
routing encapsulation (GRE) tunnel and an IP Security (IPSec)
tunnel), the offered rate does not include all the extra overhead
associated with tunnel encapsulation in general. Depending on the
configuration, the offered rate may include no overhead, may
include the overhead for only one tunnel encapsulation, or may
include the overhead for all tunnel encapsulations. In most of the
GRE and IPSec tunnel configurations, the offered rate includes
the overhead for GRE tunnel encapsulation only.
drop rate Rate, in kbps, at which packets are dropped from the class. The drop rate
is calculated by subtracting the number of successfully transmitted
packets from the offered rate.
Match Match criteria specified for the class of traffic. Choices include criteria
such as the Layer 3 packet length, IP precedence, IP DSCP value, MPLS
experimental value, access groups, and quality of service (QoS) groups.
For more information about the variety of match criteria that are available,
see the “Classifying Network Traffic” module in the Cisco IOS Quality of
Service Solutions Configuration Guide.
Traffic Shaping Indicates that traffic shaping based on a percentage of bandwidth has been
enabled.
Target/Average Rate Rate (percentage) used for shaping traffic and the number of packets
meeting that rate.
Byte Limit Maximum number of bytes that can be transmitted per interval. Calculated
as follows:
((Bc+Be) /8 ) x 1
Sustain bits/int Committed burst (Bc) rate.
Excess bits/int Excess burst (Be) rate.
Interval (ms) Time interval value in milliseconds (ms).
Increment (bytes) Number of credits (in bytes) received in the token bucket of the traffic
shaper during each time interval.
Adapt Active Indicates whether adaptive shaping is enabled.
Queue Depth Current queue depth of the traffic shaper.
Packets Total number of packets that have entered the traffic shaper system.
Bytes Total number of bytes that have entered the traffic shaper system.
Table 50 show policy-map interface Field Descriptions—Configured for Percentage-Based Policing
and Shaping (with Traffic Shaping Enabled)
1
(continued)
Field Description